mount efi clover windows hackintosh diskpart

Type assign letter= x at the prompt (where x is the drive letter that you want to assign), and then press ENTER.Īfter you follow these steps, you can access an EFI system partition by using the drive letter that you assign to the partition with the Diskpart utility.

Type select partition n at the prompt (where n is number for the mapped ESP partition), and then press ENTER.

When the Diskpart utility starts, type select disk n at the prompt (where n is number for the mapped ESP disk), and then press ENTER.

Select Start, select Run, type diskpart in the Open box, and then select OK.

To work around this behavior, use the Diskpart utility (Dispart.exe) instead of the Mountvol tool. This behavior occurs because the Mountvol utility isn't supported in WinPE environments.

The system cannot find the file specified.

For example, if you try to use the mountvol x: /s command, you may receive the following error message: If you use the Mountvol utility (Mountvol.exe) in a Windows Preinstall Environment (WinPE) on either a Windows XP-based or Windows Server 2003-based computer, you can't gain access to the Extensible Firmware Interface (EFI) system partition by using the mountvol /s command. You can find more information about Hackintosh and Clover on tonymac86.This article provides a solution to an issue that you can't gain access to the Extensible Firmware Interface (EFI) system partition by using the mountvol /s command when you use the Mountvol utility (Mountvol.exe) in a WinPE Environment.Īpplies to: Windows 10 - all editions, Windows Server 2012 R2 Original KB number: 315943 Symptoms In addition to that, some Clover prefixes that can help you find out what went wrong are: If everything worked fine, you can now restart and use your MacOSX boot again. Replace this path by the path where you have your ist backup) s: (go to the just mounted boot partition).

select partition 1 (select the boot EFI partition).list partition (list the partitions available on the selected disk).select disk 1 (select the disk where your Clover EFI boot has been installed.Open an administrator console (run cmd.exe as Administrator) and type the following:.If you happen to break down your MacOSX boot, but you still have a working Windows boot on the same machine, you can follow these steps in order to restore a backup of ist: That’s why it’s more than advisable to keep a backup of the /EFI/CLOVER/ist configuration file. The Clover configuration can be quite tricky, and if you’re not lucky you can easily mess it up. It is used mostly by Hackintosh users, that is, people that install MacOSX (along with other OSs, like Linux and Windows) on a non-Apple machine. Restore clover using Windows Restore your istĬlover is a boot manager that allows you to select the OS you want to boot with.

Mount efi clover windows hackintosh diskpart